Size distribution and source of heavy metals in particulate matter on the lead and zinc smelting affected area
Kai Zhang , Fahe Chai , Zilong Zheng , Qing Yang , Xuecai Zhong , Khanneh Wadinga Fomba , Guangzhu Zhou
DOI:10.1016/j.jes.2018.04.018
Received September 25, 2017,Revised , Accepted April 20, 2018, Available online April 27, 2018
Volume 30,2018,Pages 188-196
In order to understand the size distribution and the main kind of heavy metals in particulate matter on the lead and zinc smelting affected area, particulate matter (PM) and the source samples were collected in Zhuzhou, Hunan Province from December 2011 to January 2012 and the results were discussed and interpreted. Atmospheric particles were collected with different sizes by a cascade impactor. The concentrations of heavy metals in atmospheric particles of different sizes, collected from the air and from factories, were measured using an inductively coupled plasma mass spectrometry (ICP-MS). The results indicated that the average concentration of PM, chromium (Cr), arsenic (As), cadmium (Cd) and lead (Pb) in PM was 177.3 ± 33.2 μg/m3, 37.3 ± 8.8 ng/m3, 17.3 ± 8.1 ng/m3, 4.8 ± 3.1 ng/m3 and 141.6 ± 49.1 ng/m3, respectively. The size distribution of PM displayed a bimodal distribution; the maximum PM size distribution was at 1.1–2.1 μm, followed by 9–10 μm. The size distribution of As, Cd and Pb in PM was similar to the distribution of the PM mass, with peaks observed at the range of 1.1–2.1 μm and 9–10 μm ranges while for Cr, only a single-mode at 4.7–5.8 μm was observed. PM (64.7%), As (72.5%), Cd (72.2%) and Pb (75.8%) were associated with the fine mode below 2.1 μm, respectively, while Cr (46.6%) was associated with the coarse mode. The size distribution characteristics, enrichment factor, correlation coefficient values, source information and the analysis of source samples showed that As, Cd and Pb in PM were the typical heavy metal in lead and zinc smelting affected areas, which originated mainly from lead and zinc smelting sources.
